STEPS TO REMOVE TIRE AND WHEEL ASSEMBLY
STEP 1
STEP 1
STEP 1
Position the Tire Lift Caddy (TLC) near the Tire & Wheel Assembly to be removed.
STEP 2
STEP 1
STEP 1
Adjust the TLC so the Guide Pins are at the lowest point.
STEP 3
STEP 1
STEP 3
Roll the TLC under the Tire & Wheel Assembly to be removed. Raise the TLC's Tire Rollers with a 3/4" (19mm) socket using either a battery powered drill (low speed), socket wrench or by hand. Raise the Rollers until they come in contact with the tire while ensuring the TLC is centered underneath. [DO NOT lower vehicle so tire contacts TLC]
STEP 4
STEP 4
STEP 3
Note the location of the TLC Guide Pin for quick installation of the new tire.
STEP 5
STEP 4
STEP 5
With TLC positioned securely under the tire, remove the Lug Nuts on the Tire & Wheel [Follow Vehicle's Operation Manual Instructions]
STEP 6
STEP 4
STEP 5
Roll TLC away from the Vehicle with Tire & Wheel on it; maintain a steady grip and control over the Tire & Wheel when moving the TLC.
STEP 7
! NOTICE !
! NOTICE !
Lock the Caster Brakes; lower the TLC's Rollers so the Guide Pins are in the lowest position with a 3/4" (19mm) socket using either a battery powered drill (low speed), socket wrench or by hand; roll Tire & Wheel down the Tire Ramp
! NOTICE !
! NOTICE !
! NOTICE !
DO NOT over rotate the Lift Nut in either direction. Stop rotation when Guide Pin is at the highest or lowest point.
STEPS TO INSTALL TIRE AND WHEEL ASSEMBLY
STEP 1
STEP 1
STEP 1
Adjust the TLC so the Guide Pin is at the
lowest point.
STEP 2
STEP 1
STEP 1
Lock Brake on Casters; Roll Tire & Wheel
onto TLC using Tire Ramp.
STEP 3
STEP 1
STEP 3
Unlock Caster Brakes; Roll TLC to the Vehicle
with Tire & Wheel on it; maintain a steady
grip and control over the Tire & Wheel
when moving the TLC.
STEP 4
STEP 4
STEP 3
Raise TLC Tire Rollers with a 3/4” (19mm)
socket using either a battery powered drill
(low speed), socket wrench or by hand.
STEP 5
STEP 4
STEP 5
Position Tire & Wheel with the Vehicles’
Studs; may need to adjust the TLC height by
hand using the TLC tire handle; Rotate the
Tire & Wheel on the Tire Rollers to line-up
with the Studs.
STEP 6
STEP 4
STEP 5
Install the Lug Nuts to secure the Tire &
Wheel [Following Vehicle’s Operation
Manual Instructions]
STEP 7
! NOTICE !
! NOTICE !
Roll TLC away from Vehicle; Lower Vehicle
and finish Tightening Lug Nuts [following
Vehicle’s Operation Manual Instructions.]
! NOTICE !
! NOTICE !
! NOTICE !
DO NOT over rotate the Lift Nut in either direction. Stop rotation when Guide Pin is at the highest or lowest point.
